Robotron Pty Ltd G5E Manuel D’Utilisation

WiNRADiO G3XX User’s Manual

With the G3XXe model, the demodulated audio is travelling over the USB
interface, so no connection to a sound card is necessary, except, of course,
the speaker output.

Finally, connect the supplied start-up antenna to the SMA connector at the
rear of the receiver. Extend the antenna so that it is as far away from the
computer as possible.

Software Installation

1. If the PC is off, turn it on. Windows will find the receiver and automatically

start the usual New hardware found driver installation routine. Insert the
installation CD ROM into the drive, and follow on-screen instructions.

2. After installing the drivers, choose the Run command from the Start menu

in Windows and type D:INSTALL (if the CD ROM is the D: drive on your
PC).

3. This will run the application installer, which will guide you in the installation

process.

4. After all the files have been installed to your hard disk, run the WiNRADiO

G3XX application.

Note: If the receiver is not detected by Windows, you can simply skip the driver
installation procedure, insert the CD ROM, and run the installation program,
which will also install the drivers.

WiNRADiO also manufactures a wide range of
antennas and antenna accessories suitable for many
applications. The WiNRADiO AX-71C antenna
(pictured) is especially suitable for the G3XX
receivers. Visit our web site www.winradio.com for
more information about WiNRADiO range of antennas
and antenna accessories.