Teledesign Systems Inc TS4000EH Manuel D’Utilisation

Remote diagnostics is used to check the status of remote TS4000s over the air.  
This allows the radio communications for a system to be setup and tested 
independent of the host equipment. 
 
Remote diagnostics is available while the host system is in operation and can be 
accessed through serial port 1 or 2 of the TS4000.  The remote diagnostics 
screen is accessed from the main screen of the TS4000 Configuration Program. 
 
Remote diagnostics is an extra cost firmware option which can be used with any 
TS4000.  The remote diagnostics firmware option upgrade is accomplished the 
same way as a standard firmware upgrade (see Upgrading Firmware).  Please 
contact Teledesign for ordering information. 
 
When using remote diagnostics in a system with store and forward repeaters, it 
is important that the repeaters are enabled to repeat individually addressed 
packets.  The remote diagnostic packets are all individually addressed because 
only one unit is queried at a time. 
 
Many systems use network broadcast packets (received by all TS4000s) and the 
repeaters are configured only to repeat these packets.  For details see the 
section AirNet Packet Protocol – Configuration Options – Packet General. 
 
 
 
 
 

 

 
To use remote diagnostics, open the Remote Diagnostics screen of the TS4000 
Configuration Program.  This requires version 5.00 or later version of the 
configuration program. 
 
These controls configure the serial port and must be set to match the 
configuration of the TS4000s serial port.