Itron Inc. 500GR Manuel D’Utilisation
22. Verify that the encoder cable is in the correct
position in the cable slot of the gasket. Fully
tighten the screws in an alternating pattern.
Install utility-approved security seals and wires
as required.
Remote ERT module programming and requirements
notes
notes
For remote ERT module programming, see
on
page 14.
Residential module programming notes:
The ERT module is programmed based on the meter's drive rate. Take note of the index
drive rate shown on a lower dial on the index. Elster American meter index drive rates are
either 1-cubic foot, 2-cubic feet or 0.05 cubic meters (not shown below).
drive rate shown on a lower dial on the index. Elster American meter index drive rates are
either 1-cubic foot, 2-cubic feet or 0.05 cubic meters (not shown below).
Commercial module programming notes:
Take note of the index drive rate shown on the index. The ERT is programmed based on the
drive rate. Elster American commercial meter index drive rates may be 5-, 10- or 100 cubic
feet. The index shown has a 10-cubic foot drive rate.
drive rate. Elster American commercial meter index drive rates may be 5-, 10- or 100 cubic
feet. The index shown has a 10-cubic foot drive rate.
Diaphragm Meter Installation
OpenWay Riva 500G Gas ERT Module Installation Guide, Remote Mount TDC-1678-000
69
Proprietary and Confidential