TransCore 05716 Manuel D’Utilisation
Commands
7-29
Reader response:
Done
66F Load Default Operating Parameters
Command #66F loads all the factory default operating parameters except RF operat-
ing frequency. Refer to
ing frequency. Refer to
for a listing
of the defaults.
Reader response:
Done
All parameters loaded OK
Error
A parameter load failed
690N Select Presence Without Tag Report Option
Command #690N enables or disables the presence without tag report option. If the
presence without tag reporting option is enabled using command #6901, input
reports are transmitted when a tag presence is detected without the subsequent acqui-
sition of a valid tag. The value for N specifies the reports as shown in
presence without tag reporting option is enabled using command #6901, input
reports are transmitted when a tag presence is detected without the subsequent acqui-
sition of a valid tag. The value for N specifies the reports as shown in
Note: These commands only have an effect when the reader is not in MPRR mode.
Reader response:
Done
Refer to
for message format informa-
tion.
692N Select RF Control Algorithm
Command #692N selects the algorithm for turning off RF power when RF-by-input
control is enabled using command #641 Select RF-by-Input Control.
control is enabled using command #641 Select RF-by-Input Control.
The values for N specify the RF control algorithms as shown in
.
Note: These commands only have an effect when the reader is not in MPRR mode.
Table 7-12 Presence Without Tag Report Commands
Command
Report Option
6900
Disable presence without tag reports (factory
default)
default)
6901
Enable presence without tag reports
Table 7-13 RF Control Algorithm Commands
Command
RF Power Off
6920
On timeout only
6921
Timeout or tag ID acquired