TransCore 05716 Manuel D’Utilisation
Multiprotocol Rail Reader System Guide
8-4
Default Operating Parameter Settings
contains the factory default configuration settings for the MPRR operating
parameters.The default configuration settings may not be the correct operating config-
uration settings for a specific site. Changes to the configuration settings may have to
be made, depending on the site plan, as described in
uration settings for a specific site. Changes to the configuration settings may have to
be made, depending on the site plan, as described in
Chapter 2 “Developing the Site
Plan.
”
Review the default configurations shown in
to determine which parameters,
in addition to operating frequency and operating range, need to be adjusted. Refer to
Chapter 7, “Commands,”
for a complete list of parameters and the corresponding
commands.
Note: The dual-protocol MPRR internal timing varies depending on the operative tag
read mode and the type of tag in the read field.
read mode and the type of tag in the read field.
Table 8-2 MPRR Default Configuration Settings
Parameter
Setting
Command
Operating mode
Data
00
Baud rate
9600
1005
Stop bits
1
1010
Parity
None
1020
Time and data appended
Enabled
302
Auxiliary information appended
Disabled
310
Unique ID code criteria
Separation of 1 ID
4100
Tag translation mode
Disabled
452
Multi-tag sort
Disabled
454
SeGo protocol tag initialization
during multi-tag sort
during multi-tag sort
Enabled
456
Alternate group select
Disabled
496
Reader ID number
00
6000
Communications protocol
Basic
610
Error correcting protocol (ECP)
timeout
timeout
12.7 sec
612FE
Flow control
Software (XON/XOFF)
6141
Echo mode
Enabled
6171
ATA operating range
Maximum
6431F