TransCore 0596465PT15 Manuel D’Utilisation
Commands
7-9
Command #30N selects the option of appending the time and date to transmitted IDs,
error messages, presence without tag reports, and input status change reports. The
factory default setting is time and date appended (command #302).
error messages, presence without tag reports, and input status change reports. The
factory default setting is time and date appended (command #302).
The reader returns an
Error
message if its tag buffer contains data. The reset reader
command #63 may be transmitted to clear the buffer; however, tag ID data will not be
reported. If this is unacceptable, allow the buffer to empty before re-issuing append
time and date command #30N. Append Time and Date commands are shown in
reported. If this is unacceptable, allow the buffer to empty before re-issuing append
time and date command #30N. Append Time and Date commands are shown in
Table 7-4 Append Time and Date Commands
Command
Append Option
300
No time and date appended
302
Time and date appended (factory default)
The reader transmits messages with time and date appended as follows. One space
separates the time from the date.
separates the time from the date.
<string>&<HH:MM:SS.hh MM/DD/YY>
where
string
is a tag ID, error message, or report.
&
separates <string> from the time and date.
HH:MM:SS
is the time delimiter.
MM/DD/YY
is the date delimiter.
Reader response:
Done
31N Append Auxiliary Information Selection
Command #31N selects the option of appending auxiliary information to transmitted
IDs, presence-without-tag reports, and input status change reports. Auxiliary informa-
tion is not appended to error messages. The factory-default setting is no auxiliary
information appended. The N variable specifies whether or not auxiliary information
is to be appended. Append Auxiliary Information commands are shown in
IDs, presence-without-tag reports, and input status change reports. Auxiliary informa-
tion is not appended to error messages. The factory-default setting is no auxiliary
information appended. The N variable specifies whether or not auxiliary information
is to be appended. Append Auxiliary Information commands are shown in
.
Table 7-5 Append Auxiliary Information Commands
Command
Append Option
310
No auxiliary information appended (factory default)
311
Auxiliary information appended