Twinhead International Corporation E14A Manuel D’Utilisation
Chapter 2 — Getting Started
The CD-ROM,
DVD-ROM, Combo Drive, or DVD±RW
Your computer comes with a pre-installed CD-ROM, DVD-ROM, Combo
drive or DVD±RW. The CD-ROM drive is a read-only drive. It cannot be used
to write data to a recordable CD. The CD-ROM drive can read data from CDs,
including audio or video CDs. The CD-RW can perform these same functions,
as well as record information to writeable CD's. The DVD drive can read both
DVDs and CDs. Your notebook identifies the drive with the letter following the
hard drive letter. If your hard drive is D, then the CD-ROM drive will be E.
drive or DVD±RW. The CD-ROM drive is a read-only drive. It cannot be used
to write data to a recordable CD. The CD-ROM drive can read data from CDs,
including audio or video CDs. The CD-RW can perform these same functions,
as well as record information to writeable CD's. The DVD drive can read both
DVDs and CDs. Your notebook identifies the drive with the letter following the
hard drive letter. If your hard drive is D, then the CD-ROM drive will be E.
Inserting a Disk
1. Press the button on the front of the
drive to open the disk tray and pull
the tray open.
the tray open.
2. Place the disk on the tray, label
side up.
3. Place the disk on the central
spindle and press gently until the
disk clicks into place.
disk clicks into place.
4. Slide back the tray until it clicks
shut.
Removing a Disk
1. Make sure the computer is not
accessing the CD-ROM drive.
2. Press the eject button and pull the
tray all the way out.
3. Pick up the CD by the edges and
remove the CD-ROM from the tray.
Push the tray into the computer
until it closes fully.
Push the tray into the computer
until it closes fully.
Warning:
When the computer is reading from a CD-
ROM/CD-RW/DVD, the indicator light for the CD-ROM
will flash on. Do not attempt to remove a disk
while this light is active.
The lock is located to the left of the eject
button. In locked mode, the drive will stop if the
eject button is accidentally pressed when reading a
CD. When this happens, please unlock the drive,
press eject and push the tray back into the
computer before reading again.
will flash on. Do not attempt to remove a disk
while this light is active.
The lock is located to the left of the eject
button. In locked mode, the drive will stop if the
eject button is accidentally pressed when reading a
CD. When this happens, please unlock the drive,
press eject and push the tray back into the
computer before reading again.
24