Marlow Industries PCE2 Manuel D’Utilisation

 



Subsidiary of II-VI INCORPORATED 
10451 Vista Park Road 

 Dallas Texas 75238-1645 

PROPRIETARY INFORMATION

 

Cage No.: 55686 

Document Number:  020-0047 

Revision:  1 

Page:  4  of  7

 

d'exposition aux radiofréquences définies par Industrie Canada pour un environnement non contrôlé. 

Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre le dispositif et 

l'utilisateur ou des tiers. 

 

2.0 IMPORTANT 

INSTRUCTIONS 

2.1 

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, 

electric shock, and injury to persons, including the following: 

2.1.1 

Read all instructions before using this heated/cooler bed system. 

2.1.2 

“WARNING - Do not use this heated/cooled bed system with an infant, a disabled person, a 

person with diminished capacity or anyone insensitive to heat, such as a person with poor blood 

circulation.” 

2.1.3 

“WARNING - “Do not use this heated/cooled bed system with any other heated - blanket, 

comforter, quilt, sheet, mattress pad, mattress, foot warmer, throw blanket or similar heated or 

cooled bedding.” 

2.1.4 

Let cord hang free- Do not place between mattress and foundation. Do not allow the cords to be 

pinched". 

2.1.5 

Turn off or unplug when not in use. 

2.1.6 

Do not operate any heater/cooler with a damaged cord or plug or after the heater/cooler 

malfunctions, has been dropped or damaged in any manner.  Discard heater/cooler, or return to 

authorized service facility for examination and/or repair. 

2.1.7 

Do not use outdoors. 

2.1.8 

Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. 

Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it 

will not be tripped over. 

2.1.9 

To disconnect heater/cooler, turn controls to off, then remove plug from outlet. 

2.1.10  Connect to properly grounded outlets only. (This item may be omitted if the heater/cooler is not 

provided with a grounding type attachment plug.) 

2.1.11  Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may 

cause an electric shock or fire, or damage the heater/cooler. 

2.1.12  To prevent a possible fire, do not block air intakes or exhaust in any manner. 

2.1.13  Do not use on soft surfaces, like a bed, where openings may become blocked. 

2.1.14  A heater/cooler has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, 

paint, or flammable liquids are used or stored. 

2.1.15  Use this heater/cooler only as described in this manual. Any other use not recommended by the 

manufacturer may cause fire, electric shock, or injury to persons. 

2.1.16  Always plug heaters/coolers directly into a wall outlet/receptacle. Never use with an extension 

cord or relocatable power tap (outlet/power strip). 

2.1.17  Use caution when handling the unit to ensure 

2.1.18  "SAVE THESE INSTRUCTIONS"