Advance Security Inc T36 Manuel D’Utilisation

 

The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your   

transmitter to parking attendants or garage mechanics. 
When the system is in valet mode, all alarm function and remote 
start functions are bypassed, however the remote panic feature 
and remote door locks will remain operational. To use the valet 
mode, the system must first be disarmed either by using you 
remote transmitter, or by operating the Manual override 
sequence.   

   

     

1. From the disarmed condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns 
on. The LED wills remain on as long as the system is in 'valet 
mode'. 

1. Return to normal operation, turn ignition 'on'. 

2. Push and hold valet switch for 2 seconds, The LED wills turns 

off indicate the system are exiting the valet mode. 

         

             

J. CAR LOCATOR   

Under armed mode, press the 

 +  button to active car locator function. The siren 

will chirp 5 times. The parking light will flash 5 times, for you to easily locate your car. 

 

The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency. 

1. Press and hold the 

 +     button for 3 second. The alarm will immediately sound 

and the “Panic” icon will display on the OLED screen.   

2. During panic mode, the normal function of this transmitter button will be suspended. 

The transmitter 

  and 

  buttons can be used to lock and unlock the door (if the 

option is installed), however once the    button is pressed, the vehicle’s starter 
disable device, (where installed) will be enable allowing the vehicle to start. 

3. To stop the alarm, any transmitter buttons pressed and released, the panic mode will be turned off 

immediately. 

4. If the button is not pressed, the alarm will automatically stop after 30 seconds.   

    When armed, your vehicle is protected as follows: 

1. Light impact will trigger the warn-away signal.   
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the 

programmed sequence. 

The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking 
lights, and dome light will turn on to alerting of an intrusion for 30 seconds. Then it will stop and automatic 
reset and re-arm. If the one of sensors or detectors still active, the alarm system will sound a maximum of 
6 times of 30 seconds cycles. 
 

 

 

     

 

 

 

While triggering the 

alarm the OLED screen will alert user through 
melody sound and flashing trigger icon, press any 
button on the OLED remote transceiver to stop 
melody sound. 

 

 

NOISE ABATEMENT CIRCUIT: You system has “Noise Abatement Circuit”. It prevents annoying 
repetitive trigger sequences due to faulty door pin switches or environmental condition such as thunder, 
jackhammers airport noise, etc. 

 

15