Tyco Safety Products/Sensormatic IDRDR2 Manuel D’Utilisation
AGILE2 READER
8200-0222-08, REV. A
INSTALLATION AND SERVICE GUIDE
4 of 13
Reader Installation
The following parts are provided with the reader:
Part Qty.
Part
Number
Multi-frequency RFID Reader
1
0101-0092-XX
Power Supply
1
5605-0014-01
Installation and Service Guide
1
8200-0222-08
Regulatory Information for the User
1
8200-0222-04
Query Protocol Reference Guide
1
8200-0222-09
Anchor, Plastic, 10-12, 1"L, w/screw
2
2880-0098-01
IMPORTANT: Be sure the user receives Agile2
Reader Regulatory Information for the User,
8200-0222-16.
Reader Regulatory Information for the User,
8200-0222-16.
Install the Reader
You can place the reader on a shelf or mount it to a
wall.
wall.
To mount the reader on a wall:
1. Hold the reader in its mounting location and
mark the position of the mounting screws (2).
R -1
R -2
T-1
T-2
T/R -1
T/R -2
T/R -3
T/R -4
R-3
R-4
T-3
T-4
T/R-5
T/R-6
T/R-7
T/R-8
2. Drill holes for the screws and install wall
anchors if required. If wall anchors are required,
use a 6.3mm (1/4in) drill bit.
use a 6.3mm (1/4in) drill bit.
3. Insert the screws and tighten until almost flush
with the wall.
4. Slip the reader over the screws and slide down
to lock the screws in the keyhole openings.
5. Tighten the screws.
Install the Antennas
The antennas can be mounted directly to a variety
of surfaces. Follow the installation instructions
provided with the antennas.
of surfaces. Follow the installation instructions
provided with the antennas.
Connect the Reader
A = RJ-45 Ethernet port
C = RS-232
B = Safe Mode button
D = DC power input
One to eight antennas can be connected to the
reader, depending on the type of cards installed.
Silk-screen markings on the reader identify the
type of cards installed. Dual-element OmniPoint
antennas are connected to 2-port cards Single-
element OmniWave antennas are connected to 4-
port cards.
reader, depending on the type of cards installed.
Silk-screen markings on the reader identify the
type of cards installed. Dual-element OmniPoint
antennas are connected to 2-port cards Single-
element OmniWave antennas are connected to 4-
port cards.
1. Connect required UHF antennas to the ports on
the reader (see Antenna Connection Options
on page 5).
on page 5).
IMPORTANT: Connect antennas to the ports
before applying power to the reader. Any port
not having an antenna connected to it will be
disabled when the reader is powered on.
before applying power to the reader. Any port
not having an antenna connected to it will be
disabled when the reader is powered on.
2. Verify that all antennas are securely connected.
3. Connect the reader to the network by plugging
an Ethernet cable into the Ethernet port.
or
Connect the reader to a PC (personal computer)
by plugging a crossover Ethernet cable into the
Ethernet port.
by plugging a crossover Ethernet cable into the
Ethernet port.
[If DHCP is to be used, then the network must
be connected before powering up the reader.]
be connected before powering up the reader.]
Mounting
holes
A
C
B
D
4-Port cards
2-Port cards