Tyco Safety Products/Sensormatic UMEXCAL Manuel D’Utilisation
Preliminary
AMS-1070 CONTROLLER INSTALLATION GUIDE (8200-0127-06, REV. 0)
2 of 13
About the Product
An AMS-1070 controller is part of an Ultra•Max
®
security label detector. The controller powers and
controls up to four transceiver antennas, two
optional remote alarm modules, and two noise
canceling antenna kits. Figure 1 shows the system
components.
controls up to four transceiver antennas, two
optional remote alarm modules, and two noise
canceling antenna kits. Figure 1 shows the system
components.
Figure 1. System components
Installation Requirements
Verifying Equipment and Unpacking
❑
Verify that all equipment has arrived. Make sure
the system configuration is the right one for the
installation site.
the system configuration is the right one for the
installation site.
❑
Unpack major components in a back room. At
the install site, lay out parts in the order you will
need them. Do not clutter the aisle or cause a
trip hazard.
the install site, lay out parts in the order you will
need them. Do not clutter the aisle or cause a
trip hazard.
Installer/Contractor
❑
Shall have electrical work comply with the latest
national electrical code, national fire code, and
all applicable local codes and ordinances.
national electrical code, national fire code, and
all applicable local codes and ordinances.
❑
Shall coordinate all work with other trades to
avoid interference.
avoid interference.
❑
Shall verify existing site conditions and
coordinate with the owner’s representative and
appropriate utilities as required.
coordinate with the owner’s representative and
appropriate utilities as required.
❑
Shall obtain copies of all related plans,
specifications, shop drawings and addenda to
schedule and coordinate related work.
specifications, shop drawings and addenda to
schedule and coordinate related work.
❑
Shall thoroughly review the project to ensure
that all work meets or exceeds the above
requirements. Any alleged discrepancies shall
be brought to the attention of Sensormatic
Electronics.
that all work meets or exceeds the above
requirements. Any alleged discrepancies shall
be brought to the attention of Sensormatic
Electronics.
!
WARNING!
Do not install this product in hazardous
areas where highly combustible or
explosive products are stored or used.
Do not install this product in hazardous
areas where highly combustible or
explosive products are stored or used.
Site Requirements
Refer to Figure 2 for description of site
requirements and placement considerations.
requirements and placement considerations.
❑
Connect the controller to a 100-240Vac source.
No fuse exchange is required for the controller.
No fuse exchange is required for the controller.
❑
Use the appropriate power cord based on the
country of use.
country of use.
❑
Replace the controller’s slow-blow fuses only
with a fuse of the same type and rating.
with a fuse of the same type and rating.
Tools and Equipment Required
For all controller installations:
•
Phillips and slotted screwdrivers
•
Wire strippers
•
Cordless drill and phillips-head screwdriver bits
Ranger
Remote Alarm
Module
Module
Controller
Antenna