Computime Limited TS-TX Manuel D’Utilisation
MHSC
Touch Screen Full Function Signature Command Operating Instructions
Touch Screen Full Function Signature Command Operating Instructions
Page:
3
N
O
TE
Due to the sensitive temperature monitoring components in the transmitter, it is necessary to
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD display.
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD display.
WARN
IN
G
Turn appliance OFF (at the Master Switch) if you are away from your house for an extended
period of time. Never leave anything on top of the surface of the transmitter.
period of time. Never leave anything on top of the surface of the transmitter.
Initialization and Setting up
Installing Batteries:
The remote transmitter has two battery compartments, one on each end of the
transmitter. Always change all four batteries at the same time.
To install batteries,
The remote transmitter has two battery compartments, one on each end of the
transmitter. Always change all four batteries at the same time.
To install batteries,
1. Press down the battery door tab and pull out to remove the battery
door.
2. Install the batteries as indicated inside the battery compartments.
3. Close the battery door by snapping in place.
4. When
3. Close the battery door by snapping in place.
4. When
all
four batteries are installed, the transmitter will initialize for
5 seconds and then is ready for use.
5. The batteries should be replaced every 6 months or when the low
battery icon indicator is displayed.
Changing Temperature Unit
When batteries are installed in the transmitter,
1. All available icons on the LCD will be turned on then be cleared.
2. The LCD will display temperature unit: °F. Use ON ∆ to toggle the units between °F and °C within
2. The LCD will display temperature unit: °F. Use ON ∆ to toggle the units between °F and °C within
the first 5 seconds.
3. The transmitter enters Manual Mode
4. The LCD displays room temperature with the chosen unit.
4. The LCD displays room temperature with the chosen unit.
Setting Privacy Code on Transmitter and performing Learn Function:
The remote transmitter privacy code is preset in factory. In the event of activation or interference from other
nearby transmissions, change the code using the following procedures (learn function must be performed after
changing the code):
1. Press the ON/arrow button and the TIMER button at the same time to enter privacy code setup mode.
2. The setup display is shown in the figure. The four digits on the top stand for the privacy code (as the
2. The setup display is shown in the figure. The four digits on the top stand for the privacy code (as the
actual DIP switches on Monessen’s previous remotes). The default values of the four digits will be all
“1”.
“1”.
3. The first digit will be flashing upon entering the setup mode. Push the “ON” button to toggle its value
between “0” and “1”, and push the “OFF” button to jump to the next digit. The next digit will then
start flashing and the first one stops flashing. Set up the four digits to your choice.
start flashing and the first one stops flashing. Set up the four digits to your choice.
4. After setting up all the four digits, push “OFF” to finish the process and return to the previous mode.