Computime Limited TS-TX Manuel D’Utilisation
MHSC
Touch Screen Full Function Signature Command Operating Instructions
Touch Screen Full Function Signature Command Operating Instructions
Page:
5
The transmitter will operate the remote receiver from 1foot to a maximum of 30 feet. The distance is
reduced when batteries are low.
reduced when batteries are low.
Manual Mode
In this mode, the TIMER button and the THERMO button will only display
“TIMER” and “THERMO”, respectively, without showing the time and the
Set temperature. Pressing the ON/up and OFF/down buttons will change the
flame height if none of the menu buttons (TIMER, THERMO, LIGHT, FAN,
AUX) are pressed and flashing.
1. Press the ON/up button to turn on the fireplace. The flame icon on the
“TIMER” and “THERMO”, respectively, without showing the time and the
Set temperature. Pressing the ON/up and OFF/down buttons will change the
flame height if none of the menu buttons (TIMER, THERMO, LIGHT, FAN,
AUX) are pressed and flashing.
1. Press the ON/up button to turn on the fireplace. The flame icon on the
LCD displays High.
2. Press the OFF/down button to decrease the flame height and turn off the
fireplace. When the OFF/down button is pressed for three times, the flame
icon changes from High to Medium, to Low, then to Off.
icon changes from High to Medium, to Low, then to Off.
3. If the OFF button is held for more than 3 seconds at any flame height, the
fireplace will be turned off and the flame icon shows Off.
Timer Mode
Press the TIMER button to enter timer mode. The fireplace will stay on for a
period of time as specified by the timer and then be shut off by the transmitter
when the timer counts down to zero.
period of time as specified by the timer and then be shut off by the transmitter
when the timer counts down to zero.
1. When the TIMER button is pressed, the Set Time appears in the frame of
the button and flashes.
2. Use ON/up and OFF/down to increase or decrease the Set Time in 15 min
increment, between 0:00 to 6:00. Slide up and down on the arrow buttons
will increase or decrease the Set Time in 1 hour increment.
will increase or decrease the Set Time in 1 hour increment.
3. Push the TIMER button again to confirm the Set Time, the transmitter
sends an ON signal to turn on the fireplace.
4. The flashing stops and the ON/up and OFF/down buttons become flame
height controller again. The flame height will then stay as set up by the
ON/up and OFF/down buttons.
ON/up and OFF/down buttons.
5. The TIMER button can be used when the transmitter is in Manual Mode
or in Thermostat Mode. In both modes, the fireplace will be shut down
completely when the timer counts down to zero.
completely when the timer counts down to zero.
6. To exit Timer Mode,
a. Push and hold the TIMER button for 3 seconds Or
b. Use the OFF/down buttons to decrease the Set Time to zero.
b. Use the OFF/down buttons to decrease the Set Time to zero.
Thermostat Mode (Auto Mode)
Presse the THERMO button to set the transmitter in thermostat mode. The
transmitter will automatically turn on the fireplace when the room temperature
is below the set temperature and turn off the appliance when the room
temperature is above the set temperature within one degree.
transmitter will automatically turn on the fireplace when the room temperature
is below the set temperature and turn off the appliance when the room
temperature is above the set temperature within one degree.
1. When the THERMO button is pressed, the Set temperature appears in the
frame of the button and flashes.
2. Use ON/up and OFF/down to increase or decrease the Set temperature in
1 degree increment, between 45 degrees and 90 degrees. Slide up and
down on the arrow buttons will increase or decrease the Set Temperature
in 10 degrees increment.
down on the arrow buttons will increase or decrease the Set Temperature
in 10 degrees increment.