Computime Limited TS-TX Manuel D’Utilisation

MHSC                                                             

Touch Screen Full Function Signature Command Operating Instructions

 

 

Touch Screen Full Function Signature Command Operating Instructions

 Page: 

 

4

 

The Signature Command control board then needs to re-learn the new setting. 

1.  The RF receiver button on the control board must be in the on position before the learn function can 

begin. Use paper clip to depress the recessed button, one beep for RF receiver ON or two beeps for 
RF receiver OFF. 

2.  Holding the OFF button on the Command Center while turning on the master switch will activate the 

learn function for the transmitter.  

3.  After the above operation, two beeps will be given and the green LED on the Command Center will 

flash for 10 seconds.  

4.  During the 10 seconds, press the OFF button on a transmitter to learn. Another two beeps will be 

given to confirm a successful learning. 

 

 
 

 

 
 

Do not use two (2) or more remote control systems  in the same area with the same 
privacy code setting,  as they will communicate with each other.  This may cause the 
appliances to malfunction. 

 
 
Resetting the transmitter: 
 
If the transmitter is not working properly, reinstall the batteries to reset the transmitter. 

1.  Pull out at lease one of the batteries. 
2.  Press any key on the screen to discarge. 
3.  Wait for 10 seconds and then reinstall the batteries. 

Pushing and holding any key for more than 10 seconds until the display refreshes will also reset the 
transmitter. 
 

  Functions and Operations 

General: 
 

The RFSC Remote Control has two (2) operating modes: Manual and Thermostatic.  The control system 
can be set to temperature range between 45°F and 90°F.  The blower speed and flame height can be 
adjusted in either the manual and thermostatic mode.