Checkpoint Systems Inc. FISOLRR Manuel D’Utilisation
1-22
I L S O p e n P l u s 3 . 0 I n s t a l l a t i o n M a n u a l
9
Select aisle configuration for which you are configuring and click Next. For example,
select a dual aisle configuration file if there are three gates.
select a dual aisle configuration file if there are three gates.
10
Review the summary and click Next to upload the configuration.
11
Click Close when finished.
Tune the Gate Antenna
Before tuning the gate antenna, you must quit the IDReaderConfiguration software. Then
the gate can be tuned as follows:
the gate can be tuned as follows:
1
Connect a laptop to the reader on the gate:
a
Disconnect RJ45 cable between the reader and serial-to-ethernet board at the serial
port.
port.
b
Plug the Checkpoint RJ45-to-DB9 cable adapter into the serial-to-ethernet board.
c
Connect a serial cable from the RJ45-to-DB9 cable adapter to the laptop’s serial
port.
port.
2
Launch DATuningTool software.
3
Click Detect Reader.
Figure 1.22
Detect Reader
4
Select the COM port your computer is using.
5
Verify 255 is listed in the BusAdr field.
6
Click Detect.
7
Use Settings to enter the configuration: