Checkpoint Systems Inc. FISOLRR Manuel D’Utilisation

I L S   O p e n   P l u s   E x i t   A n t e n n a   I n s t a l l a t i o n :   T e s t i n g   t h e   G a t e   A n t e n n a  

1-23

select Single Mode 

Number of Antennas: 1

Select with Multiplexer

Number of Tuning Iterations: 3

Click Start Tuning and wait until the tuning process is finished. The tuning status is 
displayed after each tuning pass. After successful tuning, both antennas are shown in 
green.

If this does not succeed on the first try, start the process over again by clicking Start 
Tuning.

Once finished, close the DATuningTool program.

After tuning the gate antenna, you can verify that it functions properly using the Reader, 
the ISOStart service software, and a Smart Tag. This procedure tests the noise level and 
performance of the gate.

With your computer still connected to the gate, launch the ISOStart program.

Click Test and Measurement.

Click Noise Level and click Start.

You should see these values: 

Average: 300-750mV

Difference (Max-Min): < 20mV

If the values are not seen, check the following:

Are all cables pulled tight and do they make good contact?

Were the ring cores installed in the antenna cable?

Were the cables routed as specified?

Are other RFID systems installed nearby?

Are there large metal parts near the antenna (distance < 1.0 m)?

Are there devices nearby which may emit noise interference (larger machines or 
wireless devices)?

To determine which devices may be disturbing the gate, briefly disconnect them from 
the mains.

Click Test and Measurement.

Click ISO Inventory and click Start.

Carry a tag through the detection zone of the gates.