Checkpoint Systems Inc. FISOLRR Manuel D’Utilisation
1-24
I L S O p e n P l u s 3 . 0 I n s t a l l a t i o n M a n u a l
4
Read the serial number and tag type in the display.
Performance Testing
In this test, the capture area of the gate antenna described
is verified. For other tags or other configurations the indicated ranges and read
areas may differ accordingly.
Figure 1.23
Peformance Test of the Gate Antenna
1
The test begins by checking the read range outside the gate (see Fig. points (1) and (2)),
assuming the configuration and locality permit it.
assuming the configuration and locality permit it.
2
Launch the ISOStart program and click ISO Inventory.
3
If the tag is oriented parallel to the antenna towards the outside, a read range of 50 to
60 cm (19.7” to 23.6”) should be achieved.
60 cm (19.7” to 23.6”) should be achieved.
4
Check the three tag orientations inside the gate. This corresponds to the lines and
orientations (3), (4), and (5).
orientations (3), (4), and (5).
5
Slowly move the tag in the vertical and parallel direction with respect to the antenna
along the line (3) from one side to the other. The tag should always be read.
along the line (3) from one side to the other. The tag should always be read.
6
Repeat this along the line (4) in the vertical tag direction transverse to the antenna and
on the line (5) in the horizontal tag orientation. Again, the tag should always be read.
on the line (5) in the horizontal tag orientation. Again, the tag should always be read.
The tag should be read within the gate when moving horizontally through the gate in
all 3 read orientations.
all 3 read orientations.
If one or more “holes” are detected, check the noise values on the Reader (see
The following may result in faulty readings:
•
Antenna improperly installed (orientation, antenna distance, check cabling)