Somfy Systems RSZ Manuel D’Utilisation
10
Adding Remotes, Creating Groups and Pairing to Z-Wave Smart Systems
Adding a New Remote When the Only Remote Controlling the Shade is Lost
1. Press and hold the program button on the
headrail/motor end, the LED will flash green
then amber. When the shade jogs once,
release the button and the LED will turn solid
amber and turn off. The motor is now ready to
learn a new remote.
then amber. When the shade jogs once,
release the button and the LED will turn solid
amber and turn off. The motor is now ready to
learn a new remote.
2x
Your motorized shades are pre-programmed from the factory with the appropriate pairing and grouping between remotes
and shade motors. There are several scenarios when additional programming steps will be required. The next sections
explain how to accomplish the most common scenarios you will encounter. If the appropriate scenario is not included,
please contact a customer service representative prior to attempting any adjustments.
and shade motors. There are several scenarios when additional programming steps will be required. The next sections
explain how to accomplish the most common scenarios you will encounter. If the appropriate scenario is not included,
please contact a customer service representative prior to attempting any adjustments.
If you no longer have your remote, or the remote no longer works, follow these steps.
2. Using a paper clip or a similar item, press
and release the programming button located
on the back side of the new remote twice in
rapid succession (two taps within a second
in between). The LED on the remote will flash
alternatively amber and green.
on the back side of the new remote twice in
rapid succession (two taps within a second
in between). The LED on the remote will flash
alternatively amber and green.
3. Press and hold the program button on the
headrail/motor end until the LED flashes green,
then release the button. This places the motor
into a learning mode for approximately
20 seconds. (LED continues to flash green.)
then release the button. This places the motor
into a learning mode for approximately
20 seconds. (LED continues to flash green.)
4. The shade will jog, confirming the motor and
remote are now paired.