Somfy Systems RSZ Manuel D’Utilisation

GRABER

GRABER

GRABER

8

If your shade system includes an optional single-channel remote as a group control, it has been pre-programmed to  
control your shades. The default        position (intermediate position) of all shades is pre-set to mid-legnth. To change the 
        position on multiple shades, follow these steps.

Note: Always adjust the upper and lower limits before adjusting your        position. After adjusting the upper or lower 
limits, the        position will reset to the new mid-legnth position.

Installer Note: You are required to access the motor head to adjust the        position.

1.  Press and release the        button to bring the 

group of shades to their pre-programmed 
         position.

2.  In order to adjust the        position of each 

shade, you must first target the individual 
shade you want to adjust. To do this, press 
and release the back of the single-channel 
remote (1 tap). The LED on the remote will 
alternattely flash green. Then on the shade 
that you want to adjust, press and hold the 
program button on the headrail/motor end 
until the LED begins to flash green and  
release. the shade will jog. 

3.  Using the two-button remote that controls the 

shade, adjust the shade to the new desired 
position. 

4.  Using the single-channel remote, press and 

HOLD the        button until the LED turns 
amber and release the button. The 
position of the target shade is now reset. 
 
 
 

5.  Repeat process for additional shades to  

adjust the new desired position.