Rockwell Collins Inc. 8222210 Manuel D’Utilisation
D r a f t 1 A - C I S C O C O N F I D E N T I A L
2-6
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
Chapter 2 Installing the Access Point
Mounting Overview
Mounting Overview
You can mount the access point on any of the following surfaces:
•
Horizontal or vertical flat surfaces, such as walls or ceilings
•
Suspended ceilings (below and above)
The access point ships with a detachable mounting plate and the necessary mounting hardware. Because
it is detachable, you can use the mounting plate as a template to mark the positions of the mounting holes
for your installation. You then install the mounting plate and attach the access point when you are ready.
Refer to
it is detachable, you can use the mounting plate as a template to mark the positions of the mounting holes
for your installation. You then install the mounting plate and attach the access point when you are ready.
Refer to
to locate the various mounting holes for the method you intend to use.
Figure 2-3
Mounting Plate
--- TBD ----
Note
The Cisco Aironet 1240AG Series Access Point provides adequate fire resistance and low
smoke-producing characteristics suitable for operation in a building's environmental air space (such as
above suspended ceilings) in accordance with Section 300-22(C) of the National Electrical Code (NEC).
smoke-producing characteristics suitable for operation in a building's environmental air space (such as
above suspended ceilings) in accordance with Section 300-22(C) of the National Electrical Code (NEC).
Caution
Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for operation in a
building’s environmental air space; no other power injectors or power modules have been tested to UL 2043
and they should not be placed in a building’s environmental air space, such as above suspended ceilings.
building’s environmental air space; no other power injectors or power modules have been tested to UL 2043
and they should not be placed in a building’s environmental air space, such as above suspended ceilings.
Note
When mounting the access point in a building’s environmental air space, you must use Ethernet cable
suitable for operation in environmental air space in accordance with Section 300-22(C) of the National
Electrical Code (NEC).
suitable for operation in environmental air space in accordance with Section 300-22(C) of the National
Electrical Code (NEC).
A mounting hardware kit is provided that contains the hardware and fasteners necessary to mount the
access point. Refer to the
access point. Refer to the
to identify the materials you need to mount your access point, then
go to the section containing the specific mounting procedure.
1
Access point mount
5
Locking detent
2
Cable tie points
6
Wall cable access
3
Ceiling mount holes
7
Suspended ceiling cable access
4
Access point mounts
8
Security hasp
1
5
4
6
7
3
8
2
3
4
65863
2