CCL ELECTRONICS LTD 3110A1703 Manuel D’Utilisation
Warning: Changes or modifications to this unit not expressly
approved by the partyresponsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a ClassB digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if notinstalled and used in accordance with the
instructions, may cause harmful interferenceto radio
communications.
However, there is no guarantee that interference will not occur
in a particularinstallation. If this equipment does cause harmful
interference to radio or televisionreception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
- Consult the dealer or experienced radio/TV technician for help
“This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.”
“This radio transmitter (identify the device by certification
number, or model number if Category II) has been approved
by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain indicated.
Antenna types not included in this list, having a gain greater
than the maximum gain indicated for that type, are strictly
prohibited for use with this device.”
“Caution: To maintain the compliance with the RF exposure
guideline, place the unit at least 20 cm from nearby persons.”
Le présent appareil est conforme aux CNR d’ Part 15 of the FCC
applicables aux appareils radio exempts de licence.
Le fonctionnement est autorisé aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Le présent émetteur (identifier l’appareil par son numéro
d’homologation ou par son numéro de modèle, s’il s’agit d’un
appareil de catégorie II) a été approuvé par Industrie Canada
pour fonctionner avec les types d’antennes énumérées
ci-dessous et ayant un gain admissible maximal. Il est
strictement interdit d’utiliser les types d’antennes non incluses
dans cette liste, et dont le gain est supérieur au gain maximal
indiqué, avec cet appareil.
Mise en garde : Pour assurer la conformité aux lignes
directrices concernant l’exposition aux RF, placer l’appareil
à au moins 20 cm des personnes.