Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Fiche De Données

379

SAM4E [DATASHEET]

Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14

The debouncing period duration is configurable. The period is made for all debouncers (i.e., the duration cannot be
adjusted separately for each debouncer). The number of successive identical samples to wake up the system can
be configured from 2 up to 8 in the LPDBC field of SUPC_WUMR. The period of time between two samples can be
configured by programming the TPERIOD field in the RTC_MR. Power parameters can be adjusted by modifying
the period of time in the THIGH field in RTC_MR.

The wake-up polarity of the inputs can be independently configured by writing WKUPT0 and/ or WKUPT1 fields in
SUPC_WUMR.

In order to determine which wake-up/tamper pin triggers the system wake-up, a status flag is associated for each
low-power debouncer. These flags are read in SUPC_SR.

A debounce event (tamper detection) can perform an immediate clear (0 delay) on the first half the general-
purpose backup registers (GPBR). The LPDBCCLR bit must be set in SUPC_MR. 

Note that it is not mandatory to use the RTCOUTx pin when using the WKUP0/WKUP1 pins as tampering inputs in
any mode. Using the RTCOUTx pin provides a “sampling mode” to further reduce the power consumption of the

MCU

WKUP0

WKUP1

RTCOUTx

Pull-up
Resistor

Pull-up
Resistor

GND

GND

GND

MCU

WKUP0

WKUP1

RTCOUTx

Pull-down

Resistors

GND

GND

GND