ONKYO TX-8020B Fiche De Données
En-
18
See “Recording” for an explanation of recording ( page 23).
Notes:
• The receiver must be turned on for recording. Recording is not possible while it’s in Standby mode.
• For European model, sources connected to a digital input cannot be recorded. Only analog inputs can be recorded.
• DTS signals will be recorded as noise, so don’t attempt analog recording of DTS CDs or LDs.
• The receiver must be turned on for recording. Recording is not possible while it’s in Standby mode.
• For European model, sources connected to a digital input cannot be recorded. Only analog inputs can be recorded.
• DTS signals will be recorded as noise, so don’t attempt analog recording of DTS CDs or LDs.
Connect the receiver’s power cord to a suitable wall outlet.
Notes:
• Before connecting the power cord, connect all of your speakers and components.
• Turning on the receiver may cause a momentary power surge that might interfere with other electrical equipment on
Notes:
• Before connecting the power cord, connect all of your speakers and components.
• Turning on the receiver may cause a momentary power surge that might interfere with other electrical equipment on
the same circuit. If this is a problem, plug the receiver into a different branch circuit.
Connecting a Recording Component
Cassette tape deck, CDR, etc.
Analog audio cable
Connecting the Power Cord