ONKYO TX-8020B Fiche De Données
En-
23
Recording
Unless you have the full consent of the copyright holder, copyright laws prohibit using your
recordings for anything other than personal enjoyment!
recordings for anything other than personal enjoyment!
This section explains how to record the selected input source to a component with recording capability, and how to
record audio from different sources.
record audio from different sources.
Audio sources can be recorded to a recorder (e.g.,
cassette tape deck, CDR).
cassette tape deck, CDR).
1
Prepare the recorder:
• Set the recorder so that it’s ready for recording.
• If necessary, adjust the recording level on the
• Set the recorder so that it’s ready for recording.
• If necessary, adjust the recording level on the
recorder.
• See the recorder’s manual for more information.
2
Use the receiver’s [INPUT] selector, or the
remote controller’s INPUT SELECTOR
buttons to select the component that you
want to record from.
remote controller’s INPUT SELECTOR
buttons to select the component that you
want to record from.
3
Start playback on the component selected
in step 1.
in step 1.
Notes:
• If you select another input source during recording,
• If you select another input source during recording,
the newly selected input source will be recorded.
• The volume, balance, mute and tone controls have no
effect on the signal being recorded.
INPUT
INPUT
SELECTOR
SELECTOR
Recording the Input Source