BENDIX BW2428 Manuel D’Utilisation

The EC-60

™

 controller’s ABS function utilizes the following 

components:
•  Bendix

®

 WS-24

™

 wheel speed sensors (4 or 6, 

depending on ECU and configuration). Each sensor is 

installed with a Bendix Sensor Clamping Sleeve

•  Bendix

®

 M-32

™

 or M-32QR

™

 Pressure Modulator Valves 

(4, 5, or 6 depending on ECU and configuration)

•  Dash-mounted tractor ABS Indicator Lamp
•  Service brake relay valve
•  Dash-mounted trailer ABS Indicator Lamp (used on all 

towing vehicles manufactured after March 1, 2001)

•  Optional blink code activation switch
•  Optional ABS off-road switch. (Off-road feature is not 

available on all ECUs - See Chart 1.)

The EC-60

™

 controller ATC function utilizes the following 

additional components:
•  Traction control valve (may be integral to the service 

brake relay valve or a stand-alone device)

•  Dash-mounted ATC status/indicator lamp
•  J1939 serial communication to engine control module
•  Stop lamp switch input (may be provided using the ECU 

hardware input or J1939)

•  Optional ATC off-road switch

Cab-mounted EC-60

™

 controllers are not protected against 

moisture, and must be mounted in an environmentally 

protected area.
All wire harness connectors must be properly seated.  The 

use of secondary locks is strongly recommended.
CAUTION:  All unused ECU connectors must be covered 

and receive any necessary protection from moisture, etc.
Cab ECUs utilize connectors from the AMP MCP 2.8 

product family.

Frame-mounted EC-60

™

 controllers may be mounted on 

the vehicle frame, but only in locations where they will not 

be subjected to direct tire spray.  ECU mounting bolts must 

be torqued to 7.5 to 9 Nm.
CAUTION:  The frame wire harness connectors must be 

properly seated with the seals intact (undamaged).  All 

unused connector terminals must be plugged with the 

appropriate sealing plugs.  Failure to properly seat or 

seal the connectors could result in moisture or corrosion 

damage to the connector terminals.  ECUs damaged by 

moisture and/or corrosion are not covered under the Bendix 

warranty.
Frame ECUs utilize Deutsch connectors.