SSI America Video Gaming Accessories 9200 Manuel D’Utilisation

SSi Manual SERIES 9200

16                                              Programmable Dual-loop

Program Display

Pressing the “Program” key displays the “default program status” page.

The Program Status display shows the last program loaded into the program run buffer and its status.  If
the program is running, the active step number is highlighted, and the Status is “Running”. A red “ALM”

block in the top right corner of the screen displays an alarm condition.

The Program display has six active buttons located on the right side of the display. These are activated by

touching the inside of the blocks. The active buttons are Soak Adjust, Load, Stop, Hold, Cont, Alm Ack

(Alarm Acknowledge) and Esc.

•  The Soak Adjust button allows you to enter a “new” value for the time remaining in the

current soak or ramp cycle. A soak or ramp cycle must be running for a change in soak/ramp

time to be adjusted.

•  The Load button allows the operator to enter the recipe number to be run and to view the

recipe before pushing the “run” button. Pushing the “run” button starts the recipe. If a recipe

program is “running” and the operator enters a “new” recipe program it can be viewed and

modified. The recipe does not become active until the “run” button is pushed. Pressing “run”

places the program currently being viewed in the active memory and will begin to run the
“new” recipe. You can start the program in any “step”, simply by moving the highlight down to

the step that that the program needs to be started in, and then pressing the “Run” key.
While reviewing the program that is about to be run, certain parameters within those steps can

be modified. You can change the set points, the time and the options. You CAN NOT delete a

step, or modify it’s “OPT CODE”.