Panasonic Arbitrator 360 Mode D’Emploi

10

11

In the cases shown below, the actual prerecord and 

postrecord time may be shorter than the respective setting.

Prerecord time will be shorter.

[REC] button pressed

(Recording starts)

[STOP] button pressed

(Recording stops)

Actual recording time

Prerecord time

Postrecord time

(Time)

Startup completed

Post-recording will be terminated and next recording 

starts. There is no pre-recording interval for the second 

recording.

[STOP] button 

pressed

[REC] button pressed

(Post-recording halted and 

next recording starts)

[STOP] button 

pressed

(Recording stops)

Actual recording time

Prerecord time

Postrecord time

(Time)

If you press the [REC] button and [STOP] button 
alternately in rapid succession, the system may not 
separate the two recording sessions, resulting in a single 
video file.
If the remaining capacity of the SDHC Memory Card is 
low, the prerecord time or postrecord time may become 
shorter.
Pre-recording is interrupted by playback, trial shoot 
(RecCheck) or administrator setup.
Post-recording is interrupted by playback, trial shoot 
(RecCheck), automatic file restoration or administrator 
setup.

•

•

•

•

You can select and record video input at the [CAMERA] 

[1], [], [], [4], [5], or [6] connector on the rear panel of 

the recorder. Also, when the action set for the detection of 

trigger signals  

(GPI1-16) is “P1REC”, “PREC” or “PREC” and the 

trigger signal is enabled, the selected video is recorded. If 

pre-recording is enabled and the video source is switched 

by a recording trigger, the prerecord video is taken from the 

source selected before switching, and the video is taken 

from the source selected after switching. You can select 

whether the video source is switched by the recording trigger 

or not, as well as selecting which video is recorded upon 

switching.
Example: When video input set for “PREC” is switched to 

that set for “P1REC”

Recording start trigger activation

(Time)

Recording of signal from the 

connector set for “P2REC”

Recording of signal from the 

connector set for “P1REC”

Pre-recording

Recording after 

trigger activation

When switching video input, the video or audio may be 
briefly disrupted.
For best results, minimize the amount of video source 
switching while recording. 

•

•

Playback with the remote control panel is not available 

at present. Upgrading is scheduled for the future. 

For playback, it is recommended to use the Front-End 

application or Back-End Client application.