Panasonic Arbitrator 360 Mode D’Emploi

88

89

If “Camera1” has not be set for any of Preset1, Preset2, and 

Preset 3 on the Video Allocation screen in Administrator 

setup, the Camera1 screen cannot be selected.
Page 1

Use this function to enter maximum zoom ratio.

Setting : ×22, ×220

Use this function to set the level of camera input gain control.

Setting : HIGH, OFF, LOW, MID

Use this function to turn backlight compensation on or off 

when the power is on.

Setting : OFF, ON, LAST 

*

1

Use this function to adjust brightness when the power is on. 

Setting : 0,  -2, -1, +1, +2, LAST 

*

1

Use this function to determine whether to vertically flip 

camera video image or not.

Setting : OFF, ON

Use this function to set the target zoom-in ratio.

Setting : ×10, ×15, ×22, ×1, ×2, ×3, ×4, ×5, ×7

Use this function to set the zoom-in pause time. 

Setting : 3 s, 5 s, 8 s

Use this function to set the zoom-end ratio for auto zoom.

Setting: x1, x2, x3, x4, x5, x7, x10, x15, x22, LAST 

*

1

Use this function to turn the [REC] lamp on the camera 

connected to the [CAMERA 1] connector on or off when the 

power is on.

Setting : ON, LAST 

*

1

,OFF 

Use this function to set the IR function when the power is on. 

Setting : AUTO 

*

2

, OFF, ON, LAST 

*

1

Use this function to set the IR function level during automatic 

switching.

Setting : LOW, HIGH

Use this function to set the IR function detection time during 

automatic switching.

Setting : 30 s, 60 s, 300 s, 10 s

Selects color camera focusing method when, 

[Init LPR Mode] is set to “DISABLE”.
[Init LPR Mode] is set to “ENABLE” and [LPR Mode] is set 
to “PATROL”.
A recording trigger starts recording when [Init LPR Mode] 
is set to “ENABLE” and [LPR Mode] is set to “LPR”. 

PRESET  :  When the zoom is 3x or below, the camera is 

focused at about 15 m (50 feet). Subsequent 

zooming will engage auto focus.

DISABLE  :  Focus is locked at about 40 m (130 feet) and 

auto focus is not available.

:  Auto focus goes into operation when the 

zoom ratio is changed. 

Enables or disables the LPR function (license plate 

recognition) when the recorder is turned on.

DISABLE :  Color camera shutter speed changes to 

“AUTO”. The zoom position for the camera at 

power on returns to the position it had when 

the power was last turned off.

ENABLE  :  Allows changes to be made to the officer 

[LPR Mode]. Values set in this mode will 

persist through a power off and become 

available at the next power on.

•
•

•

*

1   Applies the setting in effect when power was last turned off. 

Unless power is turned off properly, the operating state may not 

be saved correctly.

*

2  Automatically switches between ON and OFF.