Gerber Tools Saw 600 Manuel D’Utilisation

4 – 3

When “2 POINT,” “3 POINT,” or “4 POINT” has been set (see “4.6 Auto-Registra-

 (PAUSE) key to switch to PAUSE

mode and display the following menu.

Use the 

,  

,  

, and 

 (POSITION) keys to move the cutter pen to the

lower-right registration mark, and then press the 

 (ENTER) key. The sensor

reads between points 1 and 2 (and also between points 1 and 3 for 3-point align-

ment or 4-point alignment), and the following is displayed.

The distance between X-axis registration marks (points 1 and 2) read by the cut-

ting plotter is displayed on the left. Enter the actual distance on the right. Use the

 or  

key to move the cursor to the digit to be entered, use the 

 or  

to increase or decrease the values, and then press the 

 (ENTER) key to con-

firm. For 3-point alignment or 4-point alignment, the distance between the Y-axis

registration marks (points 1 to 3) is also displayed and should be set in the same

way. To cancel the selection(s), press the 

 (NEXT) or 

 (PREV.) key.

• If the registration-mark distance correction is set to

“5 mm,”  “10  mm,”  “50 mm,” or “STD.” the alignment
input screen is not displayed.

• The registration marks are read in accordance with the

registration-mark-detection movement distance setting.