Gerber Tools Saw 600 Manuel D’Utilisation

4 – 4

The FEED function feeds the medium forward and backward to leave faint tracks of the grit rollers on it and

prevent the media from slipping during a cutting or plotting operation.

Press the 

 (PAUSE) key to switch to PAUSE mode.

Press the 

 (NEXT) or 

 (PREV.) key until the following menu is displayed.

Press the 

 (ENTER) key to display the feed-length setting. Set the length to be

fed.

Use the 

 or  

key to set a value within the range of 1 m to 50 m, and then

press the 

 (ENTER) key. The cutting plotter performs the feed operation (moves

the medium forward and then back to the origin). To cancel the operation, press

the  

(NEXT) or 

 (PREV.) key.

Pressing the 

 (NEXT) or 

 (PREV.) key during the

feed operation aborts the feed operation and returns the
medium to its original position.

• The feed operation starts immediately once the feed length

has been set and the 

 (ENTER) key is pressed. Make sure

there are no obstructions at the front or rear of the cutting plot-
ter.

• When using roll media, either extend and load the length to be

used beforehand or use the media feed procedure (“4.3 Set-
ting the FEED function”, “4.4 Setting AUTO PRE-FEED”).
Beginning cutting or plotting without feeding the media first
may generate a position error or may cause the roll media to
fall off the stock shaft.