Avital 4103 Manuel D’Utilisation
38
© 2008 Directed Electronics. All rights reserved.
10 PANIC
ON
/Off: When on, the panic feature can be activated at any
time from the remote and will sound for 30 seconds. When off the panic
feature does not function.
feature does not function.
➢
Menu 2
1 ENGINE CHECK VIRTUAL TACH (1):
When set to “virtual tach” (1) the remote start monitors the cranking volt-
age of the vehicle and sets it as a reference point. Fifteen seconds after
the crank output sequence the remote start checks the voltage again to
determine if the vehicle is running.
When set to voltage, (2) the unit cranks the starter for the programmed
time and then attempts to sense that the engine is running by detecting
an increase in voltage. If programmed Off (3) the vehicle cranks for
the programmed crank time. The tach setting or voltage setting is not
checked to verify that the car is running. In the OFF setting, if the vehicle
fails to start, the ignition stays on for the run duration. Using tach or
either of the voltage settings is recommended.
When set to Tachometer, (4) the unit references the learned tach signal
to disengage the starter. In addition it will monitor the RPM and shut
down if the engine RPM is too high or too low.
When set to “virtual tach” (1) the remote start monitors the cranking volt-
age of the vehicle and sets it as a reference point. Fifteen seconds after
the crank output sequence the remote start checks the voltage again to
determine if the vehicle is running.
When set to voltage, (2) the unit cranks the starter for the programmed
time and then attempts to sense that the engine is running by detecting
an increase in voltage. If programmed Off (3) the vehicle cranks for
the programmed crank time. The tach setting or voltage setting is not
checked to verify that the car is running. In the OFF setting, if the vehicle
fails to start, the ignition stays on for the run duration. Using tach or
either of the voltage settings is recommended.
When set to Tachometer, (4) the unit references the learned tach signal
to disengage the starter. In addition it will monitor the RPM and shut
down if the engine RPM is too high or too low.
2 RUN TIME—
12
/24/60 MINUTES:
This feature controls how long the engine will run before it “times out”
and shuts down. Programmed to the default setting the engine will run
for 12 minutes. If the 24 or 60 minute run time is desired, change this
feature to the two or three flash setting.
and shuts down. Programmed to the default setting the engine will run
for 12 minutes. If the 24 or 60 minute run time is desired, change this
feature to the two or three flash setting.
3 PARKING LIGHTS—
CONSTANT
/FLASHING:
In the default setting, the parking lights will come on solidly for the entire
run duration. in the flashing setting, the parking lights will flash for the
entire run duration.
run duration. in the flashing setting, the parking lights will flash for the
entire run duration.