Monogram ZWE23ESHSS Manuel De Montage
10
STEP 7 REPLACE THE FREEZER
DRAWER
STEP 8 LEVEL THE FREEZER DRAWER
ATTACH AND SECURE THE DRAWER FRONT
TO THE SLIDES
A. Pull the slide Mechanism to full extension using both
TO THE SLIDES
A. Pull the slide Mechanism to full extension using both
hands simultaneously.
B. Remove the basket resting on the slides.
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to secure the door
before lifting.
C.
Lift the freezer door and place it on the slide
mechanism
D.
Replace the attachment screws and torque the
screws to 65 in-lb
E.
Adjust freezer door gap if necessary.
A.
Locate the height adjuster cam in the freezer
door. Slightly loosen the three door attachment
screws on both sides using a 3/8” hex socket
driver.
B.
Locate and loosen the cam screw using the
T-27 screw driver.
C.
Lift the door on the side requiring adjustment,
rotate the cam to required position.
0 - Initial position
1 - Lift by 0.050”
-1 - Lower by 0.050”
-2 - Lower by 0.100
-3 - Lower by 0.150”
1 - Lift by 0.050”
-1 - Lower by 0.050”
-2 - Lower by 0.100
-3 - Lower by 0.150”
D.
After adjustment tighten the 3 attachment
screws using to 65 in-lb.
Installation Instructions
Cam
Screw
Screw
Align and insert tab on
freezer door bracket into slot
on freezer slide bracket.