British Telecom Granite 43685 Manuel D’Utilisation

8

If you experience any problems, please call the Helpline on 0808 100 6556*

The 

 icon flashes in the handset display when 

you have only a few minutes talk time remaining. 

Recharge the handset before you can use it 

again. You also hear a low battery warning beep 

if the battery is low and needs recharging. During 

charging, the icon will scroll in the display.

In ideal conditions, a fully charged battery should 

give up to 10 hours talk time or 100 hours 

standby time on a single charge.
Note that new batteries do not reach full capacity 

until they have been in normal use for several days.
To keep the battery in the best condition, leave 

the handset off the base for a few hours at a time.
Running the battery right down at least once a 

week will help it last as long as possible.
The charge capacity of rechargeable batteries 

will reduce with time as they wear out, giving 

the handset less talk/standby time. Eventually 

they will need to be replaced. New batteries are 

available from the BT Granite Helpline on 0808 

100 6556*. After charging your handset for the 

first time, subsequent charging time is about 6–8 

hours a day. Batteries and handset may become 

warm during charging. This is normal.

If this product is to be used on a broadband 

line then you must ensure that it is connected 

via an ADSL microfilter. Using this product on 

a Broadband line without an ADSL microfilter 

may cause problems with this product and your 

Broadband service.
Additional BT ADSL microfilters can be purchased 

from www.shop.bt.com

Getting started

2.  Insert battery as shown below. Make sure the coloured wires line up as shown on 

the label inside the handset and the connector is plugged fully into the socket.

 

  Note: If you ever need to remove the battery, simply slide open the battery 

compartment cover and unplug the battery pack from the socket.

3.  Attach the desk mounting plinth.

  This is an optional attachment, the base can be placed flat on the desk without 

the plinth if desired.

4.  Place the handset on the base to charge for at least 24 hours. When the 

handset is fully charged the 

 icon will be displayed.

5.  When the battery is fully charged, plug one end of the telephone line cord 

into the socket marked   on the rear of the base and the other end into the 
telephone wall socket.