Multiquip GB114BS/BP Manuel D’Utilisation

Using the supplied 19 mm wrench, loosen extension 

1. 

clamp bolt (Figure 6-Q).

Carefully pull down on the adjustable extension pole 

2. 

(Figure 6-L) and lower lamp assembly.

Remove wingnut (Figure 6-D) from offset pole (Figure 

3. 

6B) and insert wrench into wrench holder. Reinsert 
wingnut and tighten.

Disconnect balloon power cable (Figure 13) from the 

1. 

lamp power cable. Place lamp power cable in a safe 
place where it will not get damage or lost..

Allow a suffi cient amount of time (15-20 minutes) for the 
lamp to cool down . The possibility exists of the balloon 
getting burned (touching the lamp). 

BALLOON

POWER

CABLE

LAMP

POWER

CABLE

LAMP

ASSEMBLY

Remove both S-type hooks (Figure 9) on the lamp 

2. 

power cable from the cable support holes on the offset 
pole.

Unzip the zipper on the protective cover (Figure 14), 

3. 

and pull down cover over balloon/lamp assembly.

Fully zip protective cover and fold velcro tab in place.

4. 

Loosen T-handle bolt (Figure 6-O) by turning 

5. 

counterclockwise and remove  lamp assembly (Figure 
6-N) from offset pole.

Store lamp assembly enclosed within its protective 

6. 

cover (Figure 16) in a safe location where it will not be 
damaged.

PROTECTIVE

COVER

ZIPPER

VELCRO

TAB

PROTECTIVE

COVER

COVER/LAMP

CARRYING

CASE