Q-Logic MKII-BASE16 Manuel D’Utilisation
GigWorks MkII-16 Switch Model MKII-BASE16
Installer's/User's Manual 59003-01 Rev. A
Installer's/User's Manual 59003-01 Rev. A
Switch Management
3-21
Switch Utilities — Setup
Setup
Figure 3-7 Setup Tab
Refer to Figure 3-7. The Setup tab enables you to set up the connection between
the Ethernet port on the PC and the Ethernet port on the Switch and to track the
communication that takes place over this connection.
the Ethernet port on the PC and the Ethernet port on the Switch and to track the
communication that takes place over this connection.
The Setup tab also enables you to read and display UART statistics.
Ethernet Port Radio Button
The Ethernet Port Radio Button, when selected, causes the Utilities to
communicate to the Switch through the Ethernet port on the PC.
communicate to the Switch through the Ethernet port on the PC.
Ethernet IP Address Box
This is the IP Address that the Utilities application uses to communicate with the
Switch. The IP Address set in the Switch at the factory is 10.0.0.1. Therefore, the
first time you use the Utilities you must use this address. You may change the
Switch IP Address using the Mmanagement. Configuration Tab.
Switch. The IP Address set in the Switch at the factory is 10.0.0.1. Therefore, the
first time you use the Utilities you must use this address. You may change the
Switch IP Address using the Mmanagement. Configuration Tab.
To change the IP Address that the Utilities application uses to communicate with
the Switch, select the IP Address and type the new address.
the Switch, select the IP Address and type the new address.