RAD Data comm Modular Access Device with Integrated Router Manuel D’Utilisation

Chapter 2  Installation and Setup 

FCD-IPM Installation and Operation Manual 

2-2 

Installation and Setup

 

 

Inspect the equipment package before unpacking. Note and report damage 
immediately. The FCD-IPM package includes the following items: 
•  FCD-IPM unit 
•  Multiservice Access Devices and Intelligent CLEs CD 
•  CBL-RJ45/D9/F/6FT configuration cable 
•  Interface adapter cable in accordance with your order 
•  AC power cable or DC power connection kit. 

The cables you need depend on the application. Cables terminated in appropriate 
connectors provide support for the following data port interfaces: 
•  V.35 interface: the interface adapter cable ends in a 34-pin female connector 
•  V.36/422 interface: the interface adapter cable ends in a 37-pin D-type 

female connector 

•  V.24/RS-232 or RS-530 interface: the interface adapter cable ends in a 25-pin 

D-type female connector 

•  X.21 interface: the interface adapter cable ends in a 15 pin D-type female 

connector. 

The FCD-IPM units are delivered completely assembled. The units are designed 

for desktop installation.  
For installation of FCD-IPM in a 19-inch rack, the RM-34 rack mount kit is 
available. For rack installation instructions, refer to the 

 guide that comes with the RM kit.  

Installation procedures for FCD-IPM are provided in the following paragraphs. 

Only the BAL/UNBAL jumpers, whose locations are shown in 

 are 

meant for user adjustment. All other internal jumpers are factory set according to 
the specific ordering requirements and are not designed for user access. The 
factory setting for the BAL/UNBAL jumpers is BAL. Before setting these jumpers, 
open the FCD-IPM case.