TANDBERG 4500 Series Manuel D’Utilisation

6

To configure Ethernet Port A, enter the following for auto-sensing mode: 

or to configure a speed and duplex, use the following command:

To display the current configuration and status of the Ethernet ports, enter: 

For example, to configure a full-duplex 100Mbps link, enter:

The default setting for the MCU is to use DHCP to obtain an IP address. You can 
assign a static IP address if you prefer or if a DHCP server is not available.
If you want the IP address of the MCU to be assigned by your DHCP server, omit this 
step.

To assign a static IP address, use the following command: 

For example, to assign an address of 192.168.1.2 where the default gateway is at 
192.168.1.1, enter:

To return to using DHCP after setting a static address, use the following 
command:

1

To display the current status of the IP address, enter: 

If you have DHCP enabled on your network and you are allowing the MCU to 
acquire its address using DHCP, the IP address that has been acquired by 
Ethernet Port A will be shown; if you have assigned a static IP address, that is the 
address that will be shown.

2

Make a note of the IP address. You will use this to access the web interface of the 
unit.

To establish a 1000Mbps connection, both ends of the link must be 
configured as auto-sensing.

If you do not have a DNS server, use 0.0.0.0 as the DNS server IP 
address.