TANDBERG 4500 Series Manuel D’Utilisation

Initial configuration

5

1

Ensure power is connected to the MCU and the Status LED is green.

2

Connect the console port of the MCU to the serial port of your PC using the 
blue RJ45 to DB9 cable supplied.

3

Use a serial terminal program, such as Secure CRT or HyperTerminal, to 
connect to the MCU. Set your terminal software to the following settings:

 

Baud rate:

38400

 

Data bits: 

8

 

Parity:

none

 

Stop bits:

1

 

Flow control: none

4

Press Enter and the following command prompt appears on the terminal: 

The default setting for the MCU Ethernet ports is auto-sensing mode. If the switch 
ports to which you connect the MCU are not also set to auto-sensing mode, then you 
need to configure the MCU Ethernet ports to use the same speed and duplex mode.

Only connect to Ethernet Port B if you need to connect the MCU to a 
second subnet.

Both ends of the Ethernet connection must be configured in the same 
way. For example, either configure both ends of the link to be auto-
sensing or configure both ends to operate at the same speed and duplex.

To establish a 1000Mbps connection, both ends of the link must be 
configured as auto-sensing.