Euro-Pro 1104HV Manuale Utente

When using an electrical appliance, safety precautions should always be followed, 
including the following: 
Read all instructions before using this sewing machine.

Danger – To reduce the risk of 
electric shock:
1. An appliance should never be left 

unattended when plugged in or 
with batteries in place.

2. Always unplug this appliance from 

the electrical outlet and/or remove 
the batteries immediately after 
using and before cleaning.

Warning – To reduce the risk of 
burns, fire, electric shock or injury to 
persons:

1. Do not allow to be used as a toy. 

Close attention is necessary when 
this appliance is used by or near 
children.

2. Use this appliance only for its 

intended use as described in this 
manual. Use only attachments 
recommended by the 
manufacturer as contained in this 
manual.

3. Never operate this appliance if it 

has a damaged cord or plug, if it is 
not working properly, if it has been 
dropped or damaged, or dropped 
into water.  Return the appliance 
to EURO-PRO Operating LLC for 
examination, repair, electrical or 
mechanical adjustment.

4. Never operate the appliance with 

any air openings blocked.  Keep 
ventilation openings of the sewing 
machine and foot control free from 
accumulation of lint, dust and 
loose cloth.

5. Keep fingers away from all moving 

parts.  Special care is required 
around the sewing machine 
needle.

6.

Always use the proper needle 
plate.  The wrong plate can 
cause the needle to break.

7.

Do not use bent needles.

8.

Do not push or pull the fabric 
while stitching.  It may deflect the 
needle causing it to break.

9.

Turn the sewing machine “Off” 
when making any adjustments in 
the needle area, such as 
threading the needle, changing 
the needle, threading the bobbin 
or changing the presser foot.

10. Always unplug the sewing 

machine from the electrical outlet 
when removing covers, 
lubricating or when making any 
other user servicing adjustments 
mentioned in the instruction 
manual.

11. Never drop or insert any object 

into any opening.

12. Do not use outdoors.
13. Do not operate where aerosol 

(spray products) are being used 
or where oxygen is being 
administered.

14. To disconnect, turn all controls to 

the “Off” position, then remove 
the plug from the electrical outlet.

15. Do not unplug by pulling on the 

power cord.  To unplug, grasp 
the plug, not the cord.

1. The sewing machine does not run when the On/Off button is pressed to the “On” 

position.
-

The batteries are inserted incorrectly.  Re-insert using the diagram provided 
inside the battery compartment.

-

Batteries are dead.  Replace with new ones.

-

Make sure that the AC/DC adapter is connected in the right position.

2. The sewing machine runs but does not sew.

-

The machine is threaded incorrectly.  Rethread the machine.

-

The needle is threaded incorrectly.  Make sure that the needle is threaded from 
left to right.

-

The needle is not properly inserted.

-

The batteries are installed backwards.  Check the placement diagram in the 
battery compartment and reinstall.

Caution: When removing fabric after sewing, first turn the hand wheel to raise the 
needle to the highest position.  Then lift the presser foot and remove the fabric.  
This will prevent the needle from bending.

3. The sewing machine runs slowly.

-

Used and new batteries are mixed together.  Replace using all new batteries.

-

Use only 4 AA batteries.

4. The sewing machine stops sewing.

-

Very heavy fabric or too many layers of fabric will force the sewing machine to 
stop.

-

The thread is tangled in the lower bobbin.  Stop the machine and cut the 
tangled threads to clear it from the machine.  Rethread both the bobbin and the 
needle.

-

Poor quality stitching, refer to “Adjust Thread Tension” section.

-

The sewing machine should run approximately for two (2) hours with new 
batteries under normal sewing conditions.  Sewing heavy fabric requires more 
power, so it will reduce the running time of the batteries.