3com 3CRUS2475 Manuale Utente

C

HAPTER

 5: E

THERNET

 C

ONFIGURATION

 C

OMMANDS

The port storm-control include-multicast Interface Configuration 
mode command enables counting multicast packets in the port 
storm-control broadcast rate command. To disable counting multicast 
packets, use the no form of this command.

port storm-control include-multicast

no port storm-control include-multicast

Multicast packets are not counted.

Interface Configuration (Ethernet) mode

InBcastPkts

Counted received broadcast packets.

OutOctets

Counted transmitted octets.

OutUcastPkts

Counted transmitted unicast packets.

OutMcastPkts

Counted transmitted multicast packets.

OutBcastPkts

Counted transmitted broadcast packets.

FCS Errors

Counted received frames that are an integral number of 
octets in length but do not pass the FCS check. 

Single Collision 
Frames

Counted frames that are involved in a single collision, and 
are subsequently transmitted successfully.

Late Collisions

Number of times that a collision is detected later than one 
slotTime into the transmission of a packet.

Excessive Collisions

Number of excessive collisions received on the selected 
interface.

Oversize Packets

Counted frames received that exceed the maximum 
permitted frame size.

Internal MAC Rx 
Errors

Counted frames for which reception fails due to an 
internal MAC sublayer received error.

Received Pause 
Frames

Counted MAC Control frames received with an opcode 
indicating the PAUSE operation.

Transmitted Pause 
Frames

Counted MAC Control frames transmitted on this 
interface with an opcode indicating the PAUSE operation.