Axor 06064XX0 Manuale Utente
4
Install the ThermoBalance II Rough
Caution: Turn the water off at the supply before
proceeding.
Both outlets must be plumbed. Do
not plug any port.
Install the hot and cold supply lines to the rough.
The hot supply must be connected to the hot inlet
and the cold supply must be connected to the cold
inlet. If the supplies are not connected to the correct
inlets, the valve cannot work correctly.
(for the sake of clarity, the plastic installation box is
not shown in this illustration.)
If using model 06627000: When connecting
If using model 06627000: When connecting
the hot and cold supplies, hold the stop steady with
a wrench to avoid stop mis-alignment, and break-
age of the factory sealed thread compound.
Install both outlet lines.
Install both outlet lines.
The valve should be level in all planes. It should
be installed so that the outside surface of the
finished wall falls between the minimum and maxi-
mum lines on the installation box. This will insure
that the trim fits properly.
English