Land Pride RCB6610 Manuale Utente

11/11/12

Refer to Figure 1-7:
1.

Remove and discard 1/2" nuts (#9) and bolts (#6). 

2.

Rotate hitch (#4) down into pulling position as shown 
in Figure 1-7. 

3.

Instructions “a” & “b” below are for cutters equipped 
with standard clevis or pintle hitch. Skip to step 4 if 
assembling LP Performance, bar-tite, or ball hitch.

a. Attach clevis level rod (#2) to center deck lug and 

clevis hitch (#1) with clevis pins (#12), flat 
washers (#10), and cotter pins (#11).

b. Secure cotter pins (#11) by bending one or more 

legs of each pin.

4.

Attach hitch frame (#4) to leveling rods (#3) by 
inserting 3/4" x 3" lg. bolts (#7) through leveling rod’s 
outside clevis plate, hitch frame (#4), and out through 
leveling rod’s inside clevis plate. Secure bolts with 
nylock nut (#8). Draw nuts up snug, do not tighten.

5.

Leveling rod adjustment will be made after the cutter 
is attached to the tractor.

IMPORTANT: Insert bolts (#7) from outside the hitch 
frame. Inserting bolts from inside the hitch will result 
in them interfering with tractor tires.

1.

Attach park jack (#14) to jack mount (#5) and secure 
with detent pin (#13). 

2.

If park jack is not vertical, adjust jack angle according 
to “Park Jack Angle Alignment” on page 26.

3.

Adjust jack up or down until clevis hitch (#1) is at 
drawbar height.

The following is proper tractor shutdown procedures. 
Always follows these procedures before dismounting 
tractor.

1.

If engaged, disengage PTO.

2.

Lower attached implement to ground, put tractor in 
park or set park brake, turn off engine, and remove 
switch key to prevent unauthorized starting.

3.

Wait for all cutter components to come to a complete 
stop before leaving the operator’s seat.

37612