Land Pride RCB6610 Manuale Utente

11/11/12

1.

Make certain park jack (#3) is properly attached to 
jack mount (#15) and secured with attachment
pin (#8). If park jack is not vertical, refer to “Park 
Jack Angle Alignment” on page 26.

2.

If clevis (#9) is not already supported horizontal, 
rotate clevis horizontal and insert customer-supplied 
hitch pin (#1) through horizontal holes in clevis (#9) 
as shown in detail A. Secure with hairpin cotter (#2).

3.

Store center 3-point link in its storage hook.

4.

Start tractor and raise 3-point arms fully up.

5.

Carefully back tractor within close proximity of 
clevis (#9).

6.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 14.

IMPORTANT: Ball detent pin (#8) must be fully 
inserted in park jack (#3) before working on or 
around a cutter not hooked to a tractor drawbar.

NOTE:  Hitch pin (#1) and hairpin cotter (#2) are 
customer-supplied.

7.

Verify tractor drawbar is adjusted correctly. Refer to 
“Drawbar Set-up” dimensions on page 12.

8.

Raise or lower park jack (#3) to align clevis (#9) with 
tractor drawbar. Drawbar should fit between lower 
and upper plates of clevis.

9.

Restart tractor and continue to back tractor up to 
cutter hitch until hitch holes in tractor drawbar and 
hitch clevis (#9) are aligned.

10. Shut tractor down properly before dismounting. 

11. Remove hairpin cotter (#2) and hitch pin (#1) from 

clevis (#9) as shown in detail A.

12. Attach cutter to tractor drawbar with hitch pin (#1) and 

hairpin cotter (#2) as shown in detail B. 

13. Lower park jack (#3) until hitch weight is supported 

by tractor drawbar. 

14. Remove park jack (#3) from jack mount (#12) and 

attach it to the weight box with detent pin (#8). Make 
sure jack base is level or lower than the jack crank 
head. See cover picture for correct positioning. 

15. Attach hitch safety chain (#4) to the tractor. Adjust 

chain length to remove all slack except what is 
necessary to permit turning. Lock chain hook 
securely to the safety chain.

16. Continue with “Hydraulic Plumbing” on page 18 

and “Driveline Installation” on page 20.

IMPORTANT: Protect park jack by attaching it to the 
weight box before moving the cutter. Make sure jack 
is stored with its base level or lower than the head to 
prevent water and freeze damage.

37986