Land Pride RCB6610 Manuale Utente

11/11/12

Refer to Figure 1-8:
1.

Make certain park jack (#3) is properly attached to 
cutter hitch and secured with detent pin (#8). If park 
jack is not vertical, refer to “Park Jack Angle 
Alignment” on page 26.

2.

Start tractor and raise 3-point arms fully up.

3.

Carefully back tractor within close proximity of 
clevis (#9).

4.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 14.

5.

Verify tractor drawbar is adjusted correctly. Refer to 
“Drawbar Set-up” dimensions on page 12.

6.

Raise or lower park jack (#3) to align clevis (#9) with 
tractor drawbar. Drawbar should fit between lower 
and upper plates of clevis.

7.

Restart tractor and continue to back tractor up to 
cutter hitch until hitch holes in tractor drawbar and 
clevis hitch (#9) are properly aligned.

8.

Shut tractor down properly before dismounting. 

9.

Attach cutter to tractor drawbar with customer 
supplied hitch pin (#1) and hairpin cotter (#2). 

10. Lower park jack (#3) until hitch weight is supported 

by drawbar.

11. Remove park jack (#3) from the hitch and attach it to 

the weight box with detent pin (#8). Make sure jack 
base is level or lower than the jack crank head. See 
cover picture for correct positioning. 

12. Attach hitch safety chain (#4) to the tractor. Adjust 

chain length to remove all slack except what is 
necessary to permit turning. Lock chain hook 
securely to the safety chain.

13. Continue with “Hydraulic Plumbing” on page 18 

and “Driveline Installation” on page 20.

IMPORTANT: Ball detent pin (#8) must be fully 
inserted in park jack (#3) before working on or 
around a cutter not hooked to a tractor drawbar.

NOTE:  Hitch pin (#1) and hairpin cotter (#2) are 
supplied by customer. 

IMPORTANT: Protect park jack by attaching it to the 
weight box before moving the cutter. Make sure jack 
is stored with its base level or lower than the head to 
prevent water and freeze damage.

35547