Land Pride RCB6610 Manuale Utente

11/11/12

331-683A

Folding Cutter Light Kit 3 1/2"

The lead wiring harness (#4) is equipped with a 7-way 
round pin connector. Make sure your tractor is equipped 
with the 7-pin electrical outlet shown in Detail C before 
purchasing this product.

1.

Lower cutter center deck and wing deck down until 
unit is resting on the lift cylinder stops and both wings 
are on the ground. 

2.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 14.

3.

Before dismounting, move hydraulic control levers 
back and forth several times to release all hydraulic 
pressure in hydraulic lines to the cutter.

4.

On the right-hand wing, remove cotter pin (#11), flat 
washer (#13), and clevis pin (#12).

5.

If not already done, thread connector (#1A) through 
hole (#18) as shown in Detail A.

NOTE:  Hydraulic hose (#14) must be located above 
light assembly (#10) as shown.

NOTE:  Amber and red lights are located as shown 
with two lamps facing back and one lamp facing 
forward on each light assembly.

6.

Attach right-hand light assembly (#10) above 
hydraulic cylinder (#17) with mounting clamp (#5) 
under the hydraulic cylinder. 

7.

Nuts (#8) must be on top. Secure unit with 
3/8"-16 x 5" GR5 bolts (#7) and locknuts (#8). Draw 
locknuts up snug, do not tighten at this time.

8.

Replace clevis pin (#12) and secure with flat 
washer (#13) and cotter pin (#11). Bend one or more 
legs of cotter pin to keep pin from falling out.

9.

Slide light assembly (#10) and mounting clamp (#5) 
as far as possible toward the rod end of hydraulic 
cylinder (#17).

10. Tighten each lock nut (#8) one-half turn in a criss-

cross pattern until all nuts are tightened to the correct 
torque. 

11. Locate magnetic light assembly (#9) outside of 

weight box as shown.

NOTE:  Right-hand wire harness (#1) has a red wire 
showing at both ends. Left-hand harness (#2) has a 
yellow wire showing at both ends.

NOTE:  See Detail B: Pins in connectors are labeled 
A, B, C, & D. Match yellow and red wires with same 
pin letters when attaching wire harness to light 
assemblies (#9 & #10) & enhance module (#3).

37842