Land Pride RCB6610 Manuale Utente

11/11/12

12. Red wires in connectors (#1A & #1B) are attached to 

pin “D” shown in Detail B on page 36. Plug 
connectors (#1A & #1B) together.

13. Yellow wires in connectors (#2A & #2B) are attached 

to pin “B” shown in Detail B on page 36. Plug 
connectors (#2A & #2B) together.

14. Route wire harnesses (#1 & #2) to enhance 

module (#3). Plug connectors at the enhance module 
to harness (#1 & #2) as follows:

a. Red wires in connectors (#1C & #1D) are 

attached to pin “B” shown in Detail B on page 36. 
Plug connectors (#1C & #1D) together.

b. Yellow wires in connectors (#2C & #2D) are 

attached to pin “C” shown in Detail B on page 36 
Plug connectors (#2C & #2D) together.

15. Attach connector (#3A) to connector (#3B) on lead 

wire harness (#4).

16. Route lead wire harness (#4) through hose 

guides (#16) and spring hose loop (#15).

17. Connect harness (#4) to the tractor’s 7-way round pin 

receiver. 

18. Start tractor and operate lights to verify hook-up is 

operating properly:

a. Turn on head lights to verify red lights illuminate.

b. Turn on flasher lights to verify amber light are 

blinking on and off.

19. If the lights did not operate properly, recheck hook-up 

of wire harnesses (#1 & #2). Make necessary 
changes to the harnesses and repeat step 18.

20. Recheck wire harness routing to make sure wires will 

not be pinched as wing decks are folded and 
unfolded and while raising and lowering cutter height.

21. Add cable ties (#6) to wire harnesses (#1, #2, & #4) 

as needed to secure them in place.

NOTE:  Route wire harnesses (#1, #2, & #4) 
alongside hydraulic hoses. Make sure harnesses 
will not become pinched as the deck is raised and 
lowered and wings are folded up and down.

Land Pride offers a 30" wide x 16" deep x 12" high tool box 
complete with locking lid and support mount for mounting 
above the center deck lift cylinder. Padlock for locking 
toolbox is supplied by customer.

1.

Attach toolbox mounting frame (#1) to the center 
deck in the location shown with 5/8"-11 x 2 3/4" GR5 
cap screws (#4), flat washers (#8), and hex flange 
lock nuts (#6). Tighten nuts to the correct torque.

2.

Attach toolbox (#2) to mounting frame with 1/2"-13 x 
1" GR5 carriage bolt (#3), flat washers (#7), and hex 
lock nut (#5). Tighten nuts to the correct torque.

3.

Remove manual holder from splitter gearbox cover 
and attach to angle brackets on toolbox mounting 
frame (#1).

NOTE:  Tool Box and Mechanical Winch use the 
same mount. Therefore, only one can be selected.

33274