Land Pride RCB6610 Manuale Utente

11/11/12

30237

1.

Pull cable hook with cable out pass the gearbox. 

2.

Attach cable to wing deck by routing cable around the 
gearbox base and clipping cable hook back to the 
cable or by hooking the cable to the wing deck side 
panel. Make sure the cable is secured and will not 
slip or come loose before raising the deck up.

3.

Turn mechanical winch handle to raise deck. If 
cylinder rod will not retract while raising the wing up, 
loosen hydraulic hose fitting on the piston side of the 
cylinder to allow pressure to bleed off while raising 
the wing up.

4.

Secure wing deck in the raised position with the 
cylinder transport lock. See “Transport Lock” 
instructions on page 32.

5.

Unhook cable and reel cable up with the hand crank.

IMPORTANT: If wing driveline profile is bent or 
twisted, disconnect that driveline from the wing 
gearbox before folding the wing up. This will protect 
both the wing and divider gearbox. Repair driveline 
before putting cutter back into service.

Refer to Figure 4-3:
An optional mechanical winch kit is available for raising 
the wing to transport position when the hydraulic system 
is not working or when the towing vehicle is not equipped 
with the proper hydraulic connections.

1.

Attach winch mounting frame (#1) to the center deck 
as shown with 5/8"-11 x 2 3/4" GR5 cap screws (#2), 
flat washers (#4), and hex flange lock nuts (#3). 
Tighten nuts to the correct torque.

NOTE:  Tool Box and Mechanical Winch use the 
same mount. Therefore, only one can be selected.