Land Pride RCM4015 Manuale Utente

10/21/15

1.

Make certain park jack (#3) is properly attached 
to the cutter hitch and secured with detent pin (#8). If 
park jack is not vertical, refer to “Park Jack Angle 
Alignment” on page 24.

2.

Store center 3-point link in its storage hook.

3.

Start tractor, raise 3-point arms fully up, and carefully 
back tractor within close proximity of clevis (#9).

4.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on this page.

5.

Verify tractor drawbar is adjusted correctly. Refer to 
“Drawbar Set-up” dimensions on page 11.

6.

Raise or lower park jack (#3) to align clevis (#9) with 
tractor drawbar. Drawbar should fit between lower 
and upper plates of clevis.

7.

Restart tractor and continue to back tractor up to 
cutter hitch until hole in tractor drawbar and holes in 
hitch clevis (#9) are aligned. 

8.

Shut tractor down properly before dismounting. 

9.

Customer to supply hitch pin and hairpin cotter. 
Insert hitch pin (#1) through top hole in clevis (#9), 
tractor drawbar, and out through bottom hole in 
clevis. Secure hitch pin with hairpin cotter (#2).

10. Lower park jack (#3) until hitch weight is supported 

by drawbar. 

IMPORTANT: Ball detent pin (#8) must be fully 
inserted in park jack (#3) before working on or 
around a cutter not hooked to a tractor drawbar.

The 5/8" bolt (#10) and spacer (#11) may be 
removed for more flexibility of hitch. If they are 
removed, an equal number of flat washers (#12) 
should be added above drawbar and below drawbar 
to remove gap between drawbar and clevis hitch. 
Adding washers with bolt and spacer removed will 
reduce drawbar and hitch ware. 
(Flat washers are customer supplied.) 

NOTE:  Hitch pin (#1) and hairpin cotter (#2) are 
supplied by customer. 

11. Remove park jack (#3) from hitch and attach it to the 

left-hand wing storage base with detent pin (#8). 
Make sure base is level with or lower than the head 
especially after the wings are folded up. See cover 
picture for correct positioning. 

12. Attach hitch safety chain (#4) to tractor. Adjust chain 

length to remove all slack except what is necessary 
to permit turning. Lock chain hook securely to the 
safety chain.

13. Continue with “Hydraulic Hook-up” on page 17 and 

27973

IMPORTANT: Protect park jack by storing it on the 
left wing deck before moving the cutter. Make sure 
jack is stored with its base level or lower than the 
head to prevent water and freeze damage.