Land Pride RCM4015 Manuale Utente
15
Section 1: Assembly & Set-up
10/21/15
RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M
LP Performance Hitch Hook-up
!
DANGER
Refer to Figure 1-12:
1.
Make certain park jack (#3) is properly attached to
cutter hitch and secured with detent pin (#8). If park
jack is not vertical, refer to “Park Jack Angle
Alignment” on page 24.
cutter hitch and secured with detent pin (#8). If park
jack is not vertical, refer to “Park Jack Angle
Alignment” on page 24.
2.
If clevis (#9) is not already supported horizontal,
rotate clevis horizontal and insert customer-supplied
hitch pin (#1) through horizontal holes in clevis (#9)
as shown in detail A. Secure with hairpin cotter (#2).
rotate clevis horizontal and insert customer-supplied
hitch pin (#1) through horizontal holes in clevis (#9)
as shown in detail A. Secure with hairpin cotter (#2).
3.
Store center 3-point link in its storage hook.
4.
Start tractor, raise 3-point arms fully up, and carefully
back tractor within close proximity of clevis (#9).
back tractor within close proximity of clevis (#9).
5.
Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 13.
to “Tractor Shutdown Procedure” on page 13.
6.
7.
Raise or lower park jack (#3) to align clevis (#9) with
tractor drawbar. Drawbar should fit between lower
and upper plates of clevis.
tractor drawbar. Drawbar should fit between lower
and upper plates of clevis.
8.
Restart tractor and continue to back tractor up to
cutter hitch until hole in tractor drawbar and holes in
hitch clevis (#9) are aligned.
cutter hitch until hole in tractor drawbar and holes in
hitch clevis (#9) are aligned.
9.
Shut tractor down properly before dismounting.
10. Remove hairpin cotter (#2) and hitch pin (#1) from
clevis (#9).
11. Attach cutter to tractor drawbar with hitch pin (#1) and
hairpin cotter (#2) as shown in detail B.
12. Lower park jack (#3) until hitch weight is supported
by tractor drawbar.
13. Remove park jack (#3) from hitch and attach it to the
left-hand wing storage base with detent pin (#8).
Make sure base is level with or lower than the head
especially after the wings are folded up. See cover
picture for correct positioning.
Make sure base is level with or lower than the head
especially after the wings are folded up. See cover
picture for correct positioning.
IMPORTANT: Jack detent pin (#8) must be fully
inserted and secured before working on or around a
cutter that is not hooked to the tractor drawbar.
inserted and secured before working on or around a
cutter that is not hooked to the tractor drawbar.
NOTE: Hitch pin (#1) and hairpin cotter (#2) are
customer-supplied.
customer-supplied.
IMPORTANT: Protect park jack by storing it on the
left wing deck before moving the cutter. Make sure
jack is stored with its base level or lower than the
head to prevent water and freeze damage.
left wing deck before moving the cutter. Make sure
jack is stored with its base level or lower than the
head to prevent water and freeze damage.
Tractor Hookup to LP Performance Hitch
Figure 1-12
14. Attach hitch safety chain (#4) to the tractor. Adjust
chain length to remove all slack except what is
necessary to permit turning. Lock chain hook
securely to the safety chain.
necessary to permit turning. Lock chain hook
securely to the safety chain.
15. Continue with “Hydraulic Hook-up” on page 17 and
37631