Land Pride RCM4015 Manuale Utente

10/21/15

Refer to Figure 1-13:
1.

Insert 1" x 5 1/2" hex bolt (#1) through hitch top 
plate (#2), hitch bushing (#3), hitch wear plate (#4), 
tractor drawbar (#5), and washer (#6) as shown. 
Secure with 1" locknut (#7). Tighten 1" locknut snugly 
to remove all play and then back nut 
one-quarter turn. Do Not torque 1" locknut.

2.

Insert two 3/4" x 6" GR5 hex bolts (#8) through, 
3/4" flat washers (#9), hitch top plate (#2), hitch wear 
plate (#4), and formed hitch support (#10) as shown. 
Secure with 3/4" locknuts (#11).

3.

Tighten 3/4" locknuts to correct torque.

4.

Remove 1" x 6 1/2" GR5 hex bolt (#12) and 1" lock 
nut (#13) from hitch bushing (#3). Keep bolt and 
locknut for reuse.

22265

IMPORTANT: Ball detent pin (#8) must be fully 
inserted in park jack (#3) before working on or 
around a cutter not hooked to a tractor drawbar.

1.

Make certain park jack (#3) is properly attached to 
cutter and secured with detent pin (#8). If park jack is 
not vertical, refer to “Park Jack Angle Alignment” 
on page 24.

2.

Store center 3-point link in its storage hook.

3.

Start tractor, raise 3-point arms fully up, and carefully 
back tractor within close proximity of clevis (#9).

4.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 13.

5.

Verify tractor drawbar is adjusted correctly. Refer to 
“Drawbar Set-up” dimensions on page 11.

6.

Raise or lower park jack (#3) to align hitch (#10) with 
bolt hole in swivel clevis (#9).

7.

Restart tractor and back tractor up to swivel 
clevis (#9) until hole in hitch bushing (#10) aligns with 
holes in swivel clevis (#9).

8.

Shut tractor down properly before dismounting. 

9.

Insert 1" x 6 1/2" GR5 hex bolt (#1) through swivel 
clevis (#9) and hitch bushing (#10). Secure hex bolt 
with locknut (#2). Tighten locknut snugly to remove 
all play. Do Not torque 1" locknut.

10. Lower park jack (#3) until hitch weight is supported 

by the drawbar. 

11. Remove park jack (#3) from hitch frame and attach it 

to the left-hand wing storage base with detent 
pin (#8). Make sure base is level with or lower than 
the head especially after the wings are folded up. 
See cover picture for correct positioning. 

12. Attach hitch safety chain (#4) to tractor. Adjust chain 

length to remove all slack except what is necessary 
to permit turning. Securely lock chain hook to the 
safety chain.

13. Continue with “Hydraulic Hook-up” on page 17 and 

26604

IMPORTANT: Protect park jack by storing it on the 
left wing deck before moving the cutter. Make sure 
jack is stored with its base level or lower than the 
head to prevent water and freeze damage.